Product Description
Part #: STF-LBO-WRX201517
This vinyl overlay is a unique addition to any vehicle. Styled after the Japanese S207, it adds contrast to the front fascia.
The material has a texture to simulate real carbon fiber.
NOTE: If you desire matte black or gloss black, it can be done upon request, but is slightly more difficult to install.
INSTALLATION
This installation requires a littler more than my other vinyls. If you have a lip, it is easier to remove it before installing this. You can pull and stretch excess material underneath the bumper.
- Heat Gun / Hair Dryer
- Water / Soap Mix or Quick Detailer Spray
- Friend (recommended)
Clean the area you're working on and leave it wet / soapy. Also wet the bottom of the vinyl. This will help you move it in place and center it up. Once you've gotten it aligned, use your friend to apply heat to the material. This dries out the material to make it adhere again and also allows it to be stretched.
Do not heat up the material too much. In general, if the heat burns you, it is too hot. The corners need to be heated up the most and require the most stretching.
You don't have to use a squeegee to install this product. You can stretch and massage out creases with your fingers. Once you have done one side, complete the other side.